How To Use Carbide Burs

Carbide burrs are tools useful for deburring most hard materials like ceramics, stone, steel, aluminum, plastics and hardwood. They offer precision, and can also be employed in cutting, shaping, grinding and chamfering hard materials.

Carbide burrs works extremely well over a variety of materials like metals (including Steel aluminum and certain) and all varieties of wood. Technology-not only on acrylics, fiberglass and plastics too. Carbide burrs will last for a very long time without chipping or breaking in order that it’s so great to use them on soft metals like gold,platinum and silver.


Which are the Attributes of Carbide Burrs In contrast to HSS Burrs?

Weighed against HSS, Carbide Burrs less difficult harder.

The Tungsten Carbide is quite hard to be able to be used in wider selection of work than HSS (Very fast Steel).

HSS can’t be as good as carbide burrs if they’re at hot temperature. Carbide Burrs can bear hotness and will run longer time.

Carbide won’t soften at hot temperature but HSS burrs is opposite. It is obvious that carbide is the perfect choice.

Utilizing Carbide Burs:

For more stability, insert the accessory bit into the oral appliance then back it out slightly before tightening down the collet nut or keyless chuck.

Avoid the use of these for drilling holes or enlarging holes that are under twice the diameter in the cutter. The tungsten carbide surface can certainly catch the inside of your hole and break the bit.

Use higher speeds for hardwoods, slower speeds for metals and slow speeds for plastics (to avoid melting at contact point).

Start at a lower speed. Then increase to the speed which gives probably the most favourable results.

Do not apply excessive pressure. It can decrease the spindle and chip cutting edges. Let the bur perform cutting.

Make use of the sides of the cutter for effective cutting. The top cuts poorly which enable it to break pressurized.

Never in-capsulate the bur in the cut. If chattering occurs, increase speed.

When working with aluminium and magnesium, consider some form of lubricant, wax or tallow, because it might help steer clear of the flutes from loading or packing.

Carbide burs, if used the correct way, will outperform HSS burs by 50
For additional information about SD-51 Carbide Burrs have a look at our new internet page

Leave a Reply